Instructions and precautions for using the power cords of Shemma M10, M20S, and M21S

1. Parameters of the official 16A power cord of Shenma :

Length: 1.5M

Power: 16A 250V

Wire diameter: pure copper 3x2 mm²

Outer cover: PVC environmentally friendly material

Interface type: National standard three-pin + Pin-shaped

Applicable machines: M10S, M20S, M21S and other series machines

Official 16A power cord

2. It is understood that the dual-plug power cord on the market consists of two 10A three-pin plugs + a 16A pin plug. The picture is as follows:

Unofficial power cord

If you use this power cord, please note the following:

1. It is easy to cause the failure rate of M10S, M20S and M21S series machines to increase.

2. Two 10A three-pin plugs need to be connected to the same phase of the three-phase electricity, otherwise it is easy to cause tripping.

3. There is a risk of short circuit at the fork of the power cord, which can easily cause safety accidents such as fire.

We hereby declare as follows:

This unofficial power cord has certain risks and is not recommended for use. If the customer uses it on their own and causes machine , power supply or other failures, the customer will bear the responsibility.

(Please use the official machine accessories provided by Shenma to ensure the normal operation and stability of the machine. If you encounter any problems, please contact our Shenma official customer service at 13360970393. Thank you!)