Ant S3 Installation Tutorial

Antminer S3 is easy to install. You can easily complete the installation of Antminer by following the steps below. Please read the following steps patiently. If you feel it is difficult, please contact our customer service. We will seriously receive and answer every customer. If the customer service does not respond for the time being, please wait patiently.

Prepare the materials:

1.          Antminer;

2.          power supply;

3.          Network cable.

Installation steps:

1.      Connect the network cable with one end connected to the router to the mining machine;

2.      Power short circuit (computer power only);

The Ant power switch I use is simple to operate and easy to use.

If you don't have an ant switch, use a paper clip to short the 24 pins (green wire + black wire (either one))

3.      Two 6-pin ports ( P-CIE ) can be connected to either the left or right side of the mining machine, or all of them can be connected.

4.      Power on and run

Antminer S3: Mining machine configuration

Ant S3 Setting Tutorial

Antminer adopts WEB interface setting, which is simple and friendly. You can easily complete the setting of Antminer by following the steps below. Please read the following steps patiently. If you really feel it is difficult, please contact our customer service. We will seriously receive and answer every customer. If the customer service does not respond for the time being, please wait patiently.

The factory IP of Antminer is 192.168.1.99 . Each miner has QC PASSED , which means that our machines have gone through multiple quality inspections before they are delivered to you. If your machine has a problem, don't worry, we provide you with a 3- month warranty.

1. Enter the IP address of your mining machine in the browser. http://192.168.1.99 The username and password are both root ( lowercase )

2.   After logging into the mining machine, click Network ----- Interface , you can see LAN and WAN . LAN is used for factory debugging. Users should modify the WAN port for mining .

Special attention:

Do not operate the LAN unless necessary!

LAN and WAN cannot be in the same IP segment!

The WAN link cannot be deleted!

3.   Click the Modify button to enter the IP configuration page of the WAN port . My router is in segment 1 .

The default IP address is 192.168.1.99 , which can be modified to 192.168.1.100 or other related network segments. The gateway address is 192.168.1.1 and the DNS address is 192.168.1.1.

DNS can also be set to 8.8.8.8 (Google) 202.106.0.20 (China Unicom) 114.114.114.114 (China Telecom)

PS : If the network segment changes, the gateway and DNS also need to change accordingly.

4. Click Miner Confinguration to enter the mining pool configuration page.

Common mining pools   www.f2pool.com   www.btcguild.com   The default mining pool is our official test mining pool.

Modify the miner to your own, click Save & Apply.

6. Enter MinerStatus and refresh a few times to see the mining data.

Antminer S3: Reset the control board

Antminer S3: Reset the control board

Antminer provides 90 days after-sales warranty service. If your mining machine control board is bricked, you can send it back for warranty, but you can also reset it as follows to save time.

Step 1: Power on the Ant for 1 minute and wait for the control board to start normally;

Step 2: Use a paper clip to press the button shown in the picture for 10 seconds (Fan 1 test);

Step 3: The mining machine will be restored to factory settings, and the IP address is 192.168.1.99 .