INNOSILICON T3+Pro 67T energy efficiency optimization notice

Dear INNOSILICON users:

The Innominator T3+ is known for its market-leading stability and is a masterpiece. In order to better give back to new machine users, our firmware team has worked tirelessly to achieve extreme stability and run for many years without being outdated.

For example, we recently optimized the firmware of the T3+Pro 67T in E mode (low power mode) . After optimization, the power consumption of the T3+Pro 67T in E mode is about 46w/t, and some actual measurements show that it is as low as 43w/t or below . The firmware optimization of the T3+57T low power mode will also be released later , with similar effects , so stay tuned .

With the continuous optimization of the later firmware, the energy efficiency of the Xindong Miner T3+ will gradually improve, and it will be further updated based on the measured performance. It will not be outdated for a long time and will not have a problem surviving the bear and bull markets. All users and friends are welcome to inquire.

1. T3+Pro 67T firmware download address:

Download link 1 (click to read the original text and download):

https://pan.baidu.com/s/1AfajprIlWgF0Fhd1wK36hw

Download link 2:

https://drive.google.com/open?id=1S3WoVTK1mIey5CZ-foPTf4TUTKSQwEhT

2. Upgrade steps and precautions:

This update requires the simultaneous update of the power supply firmware to achieve the best energy efficiency ratio. The steps for firmware update (including power supply upgrade) are as follows:

1. Use InnoMonitor for batch upgrade ( InnoMonitor download address is attached at the end of the article) . During the upgrade process and within 15 minutes after the tool prompts that the operation is successful, it is strictly forbidden to perform any operations on the mining machine, including power off, network disconnection, setting mining pool, setting operation mode, etc. Otherwise, it will cause physical damage to the power supply.

2. After the upgrade is completed, the power supply version needs to be reviewed to confirm that the power supply version of all mining machines is 9.70. If there is a version number that has not been updated, it needs to be upgraded again.

3. For the miners with blank power supply versions, select these miners, perform the standby operation on the batch operation page, perform the wake-up operation after 5 seconds, and rescan to correctly display the power supply version. It should be noted that this operation cannot be performed during the upgrade process and within 15 minutes after the upgrade is completed, otherwise the power supply will be damaged.

4. If the machine reports error code 22 after the upgrade, please contact Innosilicon after-sales service.

5. If there is no power version column in the batch tool, please follow the steps below on the "Options-Settings" page in the menu bar.

Download address of batch management software InnoMonitor :

http://www.innosilicon.com.cn/download/InnoMonitor_x64%20v2.1.4.zip